diff options
Diffstat (limited to 'source/n/vsftpd/vsftpd.conf.diff')
-rw-r--r-- | source/n/vsftpd/vsftpd.conf.diff | 48 |
1 files changed, 48 insertions, 0 deletions
diff --git a/source/n/vsftpd/vsftpd.conf.diff b/source/n/vsftpd/vsftpd.conf.diff new file mode 100644 index 000000000..230d858c8 --- /dev/null +++ b/source/n/vsftpd/vsftpd.conf.diff @@ -0,0 +1,48 @@ +--- ./vsftpd.conf.orig 2008-12-17 14:31:40.000000000 -0600 ++++ ./vsftpd.conf 2009-03-29 22:09:21.000000000 -0500 +@@ -19,7 +19,7 @@ + # + # Default umask for local users is 077. You may wish to change this to 022, + # if your users expect that (022 is used by most other ftpd's) +-#local_umask=022 ++local_umask=022 + # + # Uncomment this to allow the anonymous FTP user to upload files. This only + # has an effect if the above global write enable is activated. Also, you will +@@ -48,11 +48,11 @@ + # + # You may override where the log file goes if you like. The default is shown + # below. +-#xferlog_file=/var/log/vsftpd.log ++xferlog_file=/var/log/vsftpd.log + # + # If you want, you can have your log file in standard ftpd xferlog format. + # Note that the default log file location is /var/log/xferlog in this case. +-#xferlog_std_format=YES ++xferlog_std_format=YES + # + # You may change the default value for timing out an idle session. + #idle_session_timeout=600 +@@ -100,14 +100,17 @@ + # default to avoid remote users being able to cause excessive I/O on large + # sites. However, some broken FTP clients such as "ncftp" and "mirror" assume + # the presence of the "-R" option, so there is a strong case for enabling it. +-#ls_recurse_enable=YES ++ls_recurse_enable=YES + # +-# When "listen" directive is enabled, vsftpd runs in standalone mode and +-# listens on IPv4 sockets. This directive cannot be used in conjunction +-# with the listen_ipv6 directive. +-listen=YES ++# When "listen" directive is enabled, vsftpd runs in standalone mode (rather ++# than from inetd) and listens on IPv4 sockets. To use vsftpd in standalone ++# mode rather than with inetd, either change the line below to 'listen=YES' ++# or comment it out. This directive cannot be used in conjunction with the ++# listen_ipv6 directive. ++listen=NO + # + # This directive enables listening on IPv6 sockets. To listen on IPv4 and IPv6 + # sockets, you must run two copies of vsftpd whith two configuration files. + # Make sure, that one of the listen options is commented !! + #listen_ipv6=YES ++ |